|
This is for One very nice used counter sink/bore cutter tool holder. Shank Diameter is 1.75" and on the inside it measures 1.125" right at the end of the holder, then just past that point up inside the holder it steps up just a little bit larger in diameter then down in there about 3/4" or so it of course steps back down to a smaller diameter to keep your cutter centered in the holder. If you need a specific size of anything just ask. If in Michigan add 6% sales tax. Thanks! (Counterbore cutter eclipse twist lock tool holder 1.125 is the responsibility of Randi Lane) |
R-lane@cedar--rapids.com (Randi Lane) for more information.
