This is a set of 3 used but good condition boring heads. I could not find a name on them, but the research I did says they are made by NAREX. Could not find the part numbers on the internet, and I do not know much about these. (they were given to my father, who is a machinist) But we cannot use them for any of our machines. You will get everything in the photo, 3 boring heads, a number of holder / extension adapters?, and some boring bars. I was told that these were about $3000 each when new. Here are the numbers off the heads, and the size: I am not sure, but I beleive they are 50 taper? Please correct me if I'm wrong. (Lot of 3 narex vhu offset boring heads w/holders, etc is the responsibility of Lynn Dennis) |
lynn-dennis@cedar--rapids.com (Lynn Dennis)
for more information.