|
NEW Static Technologies WT1200 Static Tech Continuous Workstation Monitor for Single Wire Wrist Straps Unlike units that monitor just one work surface and two operators, the WT1200 is capable of actually monitoring two work surfaces and two operators. A 5V 5µA DC current provides dependable monitoring at a level that prevents harmful voltage build-up. The WT1200 uses a solid state impedance design to continuously test the connection integrity of the entire ground loop including the person, the wrist band, and the coil cord. Upper limit for wrist straps can be easily switched from 10 to 35 megohms (the 35 megohm limit is the proper setting for ANSI guidelines). Two banks of LEDs allow each workstation to be independently monitored. Flashing green LEDs indicate work surfaces meet system parameters for snap-to-ground resistance less than 3.7 megohms. Solid green LEDs indicate mats and operators are properly grounded. Failures are indicated by an audible alarm and appropriate solid red or yellow LEDs. An additional feature of the WT1200 is the flashing yellow "stand by" mode (no alarm) that indicates the wrist cord is "parked" and not in use. The WT1200 includes monitor and two remote jacks. Single wire wrist straps (any brand) must be purchased separately. Standard retail price is $179.00. Your price for this new, never-used Static Tech Continuous Workstation Monitor for Single Wire Wrist Straps in its original, unopened packaging is just $170.00! Established in 1975, HMC Electronics is a national supplier of Static Technologies products and equipment. More about us here. Products for Electronic Assembly and Repair (New static technologies WT1200 is the responsibility of Lawrence Bird) |
lawrence_bird@cedar--rapids.com (Lawrence Bird) for more information.
