ARO part # 47005-41 fits ARO series WG036, which was made for ARO overseas, so this anvil fits many other 3/8" impacts as well. You may email your dimensions if you are not sure if it fits your tool Dimensions; overall length 2.455" Length of striking lobe .615" Front shaft .499 dia. x .960 long to the square drive The rear support shaft is .399 dia. x .213 long The shoulder portion between the front shaft & striking lobe is .671 dia. x .172" long. These dimensions are my best measurements with a dial caliper, there are radiused corners on the part which affect accuracy. Feel Free to email any questions (Anvil for air impact wrench repair part aro ir 9 avail. is the responsibility of Rachelle Armstrong) |
r.armstrong@cedar--rapids.com (Rachelle Armstrong)
for more information.