|
3Mâ„¢ Scotchliteâ„¢ Removable Graphic Film with Complyâ„¢ Performance Series 680 series (white & red diagonal colour) is a durable, flexible, retroreflective tape designed for use in production of multi-color emblems, stripes, and markings. * Positionable, pressure-activated adhesive * Up to 7 years exterior durability * Suitable for most materials (steel, glass, wood, plastic, concrete) * Application surface: flat, riveted, moderately curved, or corrugated. * High reflective performance all round. * Similar daytime and nighttime appearances For application to rear and sides of large trucks, trailers, other vehicles for increased nighttime visibility. Length: 2 metres (if you order more than 2 metres, the reflective tape will be provided to you on a continuous stripe). 1 metre = 1.094 yard We have more than 20 metres available. At a -4.0Ëš entrance angle and a 0.2Ëš observation angle, unprinted series 680CR film has the following typical coefficient of retroreflection. It is expressed in candlepower per foot-candle per square foot per ASTM E810. The entrance angle is formed by a light beam striking the surface at a point and at a line that is perpendicular to the surface at the same point. An observation angle is formed by the light beam striking the reflective surface and returning to the observer. From 800 feet (249 meters), a motorist normally views a graphic at 0.2Ëš angle. Use a dry method. Do not use a detergent and water or a commercial application liquid to position the graphic. Series 680CR film has the Comply performance feature. This 3M technology is also a mechanical feature rather than an adhesive property. This feature allows air to travel through the adhesive resulting in fewer air bubbles. Use a cleaner such as the kind used for high-quality, painted surfaces. The cleaner must be wet, non-abrasive, without strong solvents, and have a pH value between 3 and 11 (neither strongly acidic nor strongly alkaline.) * Graphics exposed to severe abrasion or high pressure washing * Graphics applied to chrome substrates * Graphics applied to locomotives and rolling railroad stock * Graphics applied to truck rollup doors CAUTION: Solvents may ignite near heat or open flame. Do not use heat sources near solvents. Failure to avoid the use of heat sources near solvents can cause flash fire. You can use heat to remove Series 680CR film from flat and riveted flat surfaces Series 680CR is a removable product. On exceptions listed below, the film will remove but more than 10% of the adhesive may remain with the substrate. * Exterior, horizontal applications * Skip or tight corrugations * Stainless steel substrates * Aged paint and metals must be tested to ensure removability. Surface oxidation or chalking may result in adhesive residue upon removal. * Paint that is not firmly bonded to the substrate may be damaged when removing the film. * Paint that is not properly cured may prevent the film from being removed. (3M reflective material adhesive diagonal tape- 50MM/2M is the responsibility of Rhea Perez) |
rhea-perez@cedar--rapids.com (Rhea Perez) for more information.
