|
YOUR SOURCE FOR WELDING SUPPLIES ARCAIR SLICE PACKS - SPOT WELDERS __________________________________________________________________________________ The Millermatic® 140 is perfect for light fabrication, garage/body shops, auto body, and at home. It welds material 24 gauge to 3/16 inch. This all-in-one MIG machine has infinite voltage control with wire feed speed tracking for easy operator control. Runs on 115 Volt input power to go wherever you need to weld! ALSO AVAILABLE WITH THE Spoolmate 100 Series spoolgun * INFINITE VOLTAGE CONTROL with Manual On/Off WIRE FEED SPEED TRACKING provides a broader operating range with finer control by automatically increasing or decreasing wire feed speed when voltage is adjusted. * NEW Smooth Start patent-pending technology provides a smooth spatter-free start .Its the best starting machine in the small MIG machine catagory . No pop gun starts and no spatter to clean up. * DURABLE CAST ALUMINUM FEEDHEAD incorporates dual groove quick-change drive rolls and spring-loaded tension arm with calibrated tension knob all designed to make set up easier and faster. * SEMIAUTOMATIC CONSTANT VOLTAGE WIRE WELDING PACKAGE is capable of welding 24 gauge - 3/16 in (0.8 - 4.8 mm) mild steel. * STANDARD BUILT-IN SOLID STATE CONTACTOR CIRCUIT makes wire electrically "cold" until trigger is pulled. Makes the unit safer, and is easier to position torch to work before starting to weld. * USES 4 or 8 in SPOOLS and can be set up to weld with wire sizes .024 - .030 in mild/staninless steel and .030 -.035 in flux cored. * Add the Spoolmate™ 3035 spool gun and SGA spool gun adapter for welding with .030 (0.8 mm) aluminum wire on 14 gauge to 1/8 in material. * Easy access to output studs provides CONVENIENT POLARITY CHANGEOVER when changing from solid or flux cored wires. * Built-in Contactor - For your safety, our built-in contactor makes wire electrically "cold" when not welding. * Short Circuit Protection - Contact tip life is extended by the exclusive Miller short-circuit protection which easily resets with the release of the gun trigger. * Thermal Overload Protection - Internal components are protected from damage by thermal overload protection which automatically shuts down the unit if duty cycle is exceeded or air flow and cooling are restricted. * Miller's exclusive "Tip Saver" - Short circuit protection shuts down output when tip is shorted to the work. Extends contact tip life and protects internal components from damage. Trigger reset permits quick reset at torch. * Flux Cored ( FCAW ), (gas and self-shielded). * 10 ft (3 m), M-10 Miller MIG gun and cable assembly #195 605. * 10 ft (3 m) work cable and clamp. * Factory-installed gas solenoid valve. * Smith Argon and AR/CO 2 Mix Regulator and gas hose. * Spool of Hobart .024 solid wire and 2 .024 contact tips * 2 contact tips for .030 wire * Dual groove quick-change drive rolls for .024 or .030/.035 wire * Information / settings chart. * Set-up and operation video. B & R WELDER REPAIR SERVICE INC. 4412 SOUTHERN BUSINESS PARK DRIVE Hours : Mon-Fri 8-5 Sat 9-12 EST Email questions to : Norma.norris@cedar--rapids.com we only accept wire transfers. Please call for our banking info. Personal checks take 2 weeks to clear (Millermatic 140 mig welder # 907311 is the responsibility of Norma Norris) |
Norma.norris@cedar--rapids.com (Norma Norris) for more information.
