|
Visit for other biodiesel information and supplies. * Carbon Steel "Non-Galvanized" * 1" Spout complete with NPT nipple, welded in place! * Perfect fit for 55 Gallon Steel Drums! * With a little modification it will weld to the bottom of 15, 30 gallon drums. Many of you Biodieselers are looking for an inexpensive way to convert a Drum into a cone bottom biodiesel reactor tank, settling tank, wash tank, or drying tank.Well, look no further, because you found it. Bay Area Biodiesel Supply.com has pioneered this solution for all you home brewers out there. This funnel is spun out of this 16 gauge, non-galvanized carbon steel. The mouth of the funnel measures 22.875 inside diameter. We made this funnel, so that it would fit a wide range of Drums, because, as you know, not all drums are created equal. This funnel will fit the biggest drum we found, as well as many smaller diameter drums. Our funnel is sized to fit the large drums. It can be formed with a hammer to fit smaller drums to be welded. The neck of the funnel has a 1†NPT fitting that will allow you to the thread on your plumbing to complete your processor. If you try to have a part like this made at your local sheet metal shop you would be looking at a cost of about $145.00 for each one! At $49.95 +S&H this funnel will allow you to create a tank to suit your needs, or make as many tanks you want for a fraction of the cost. To view the instillation instructions follow this link Install Instructions (55 gallon drum funnel - cone bottom tank svo bio diesel is the responsibility of Ken Nichols) |
kennichols@cedar--rapids.com (Ken Nichols) for more information.
