|
New in box - Factory Sealed - Factory Warranty Please note that US Electrical Standards apply to this product. You must be able to convert to your countries standards. Any damage that may occur because of improper adaptation is the responsibility of the purchaser and not that of the manufacturer, Auto Arc 4500 Plasma Cutter * Rated output: 27 A at 90 VDC, 35% duty cycle * 1/15 in. standoff cutting rated: 3/8 in. (10 mm) Quality: 1/2 in. (13 mm) Sever: 5/8 in. (16 mm) * Drag cutting rated: 5/8 in. (8 mm) Quality: 3/8 in. (10 mm) Sever: 1/2 in. (13 mm) * Plasma gas flow/pressure 4.5 CFM (129 L/min.) at 60 PSI (414 kPa) * Starts without high-frequency so it will not interfere with controls or computers * NEW! Pilot arc controller increases cutting capabilities and speeds, and improves tip life * Postflow cooling circuit extends the life of the consumables and torch by cooling them with postflow air after the trigger is released * LVC line voltage compensation provides peak performance power under variable conditions (power fluctuations up to +/- 15%) for steady cuts and cleaner ending cuts * Gas/air filter/regulator inside the power source provides added protection during transportation. Standard air connection on back panel for easy gas or air hookup * ICE-27C hand-held torch with 20 ft. cable * 15 ft. heavy-duty work cable with clamp * Extra consumables (3 electrodes, 3 tips and 1 air fitting) * 10ft. power cord with 115 VAC, 20 A plug Please contact me for exact charges and discounts (Auto arc 4500 plasma cutter many extra features is the responsibility of Michael Ross) |
m_ross@cedar--rapids.com (Michael Ross) for more information.
