|
Powermatic Industrial 18" Planer 180 We strive for excellence here at USRestQuip We test and clean our equipment as soon as it arrives and determine weather this item is fit to be sold and used again to the best of our ability We start by inspecting and testing each piece of equipment if possible. If there is anything wrong, it is noted and sent to our repair division, if we cannot fix it, or it cost to much to fix it, we scrap it out for parts. Once an item has passed inspection and tested to work properly, it is sent to our detailing division where it is then cleaned as best we can do. We clean each item with the intention of making it look like an item you'd be proud to own, but as all of you know, everyone has their own idea of what clean is, just remember that most items are used and may require a little more TLC once it arrives to pass your inspection. In some cases, the items are even fully disassembled and all parts cleaned before re-assembling. ***please look at all of the other pictures below*** ************************************************************** ***WE WELCOME LOCAL PICKUP OF ITEMS*** Frame machined from extra heavy cast iron Extra wide side panels with gibs offer rigid bed support and accurate alignment bed accurately machined with extra heavy rib reinforcing for alignment and maximum strength Bed surface finish ground from a one-piece casting Bed raises and lowers on large acme-thread screw mounted on enclosed thrust bearings These sell used for between $6000 to $9000 so don't miss this opportunity to save a lot of cash. Thank you and good luck. Lot VM85000 ATTENTION THIS IS A FREIGHT ITEM LISTING, SO PLEASE READ THE FOLLOWING CAREFULLY: We do have a forklift and people at the facility to help load if you decide to pick it up yourself or send your own carrier. ATTENTION!!!!! Please read the the following carefully!!! (Powermatic industrial 18" planer 180 is the responsibility of Rhonda Brewer) |
R-Brewer@cedar--rapids.com (Rhonda Brewer) for more information.
