|
STSM HSS 1/4" Wide x 4" Dia x 1 1/4" Arbor x 24 Teeth These Cutters are High Speed Steel. Will produce a nice sharp corner. Good to cut in most metals but real good for Mild to hard Steel, copper, brass, alum etc. I have 11 of these cutters for sale. I normally sell these for $14.00 each used I am starting this action at 4.00 each cutter with no reserve. New retail cost of these cutters about $70.00 Please be aware that these cutters have been used and some may have a tooth missing or broken some may have chips but are still very usable. Most cutters here were no longer used because the sides were ground under our tolerances or we just had no more use for them. Please also note that A cutter may not be the exact width and diameter stated due to regrinding widths no less than .010 diameter within 1/2" listed. (Hss milling cutters 1/4" is the responsibility of Haley Moran) |
h-moran@cedar--rapids.com (Haley Moran) for more information.
