|
YOUR SOURCE FOR WELDING SUPPLIES ARCAIR SLICE PACKS - LENCO SPOT WELDERS ________________________________________ The XMT 350 VS multiprocess power source combines the advantages of inverter-based design with the built-in features of a high-end MIG machine. At only 80 lb (36.3 kg), the XMT 350 VS offers the portability that allows you to take it anywhere it's needed. Plus, it can operate off either single-phase or three-phase power. It's rugged construction and protected internal components ensure reliable operation, even in the most abusive working conditions. * Wind Tunnel Technology protects electrical components and PC boards from contamination. * Fan-On-Demand cooling system operates only when needed, reducing noise, energy use and amount of contaminants pulled through machine. * Lift-Arc allows TIG starting without the use of high frequency. Starts the arc without contaminating the weld with tungsten.. * Adaptive Hot Start increases the output amperage at the start of a weld if necessary, eliminating electrode sticking. * Inverter arc control technology provides greater puddle control for superior 6010 Stick electrode performance. * Line voltage compensation keeps power constant even if power input varies by +/- 10%. * Process selector switch reduces the number of control setup combinations without reducing any features. * Large, dual digital meters are easy to view and presettable to ease setting weld output. * Lighweight, aerospace-grade aluminum case offers protection with the benefit of reduced weight. * Available in VS. VS model has a simple four-position front panel and is 10 lb lighter than the CC/CV model. VS does not have remote control receptacle. * Auto-Line technology allows for any input voltage hook-up ( 208 - 575 V ) with no manual linking, providing convenience in any job setting. Ideal solution for dirty or unreliable input power.. * Reduced OCV operation - an internal dip switch enables reduced open-circuit voltage Stick welding capability, OCV is typically below 10 volts. * Air Carbon Arc Cutting and Gouging (CAC-A). (5/16" carbons). ________________________________________________________________ B & R WELDER REPAIR SERVICE INC. 4412 SOUTHERN BUSINESS PARK DRIVE Hours : Mon-Fri 8-5 Sat 9-12 EST Email questions to : l_bradford@cedar--rapids.com we only accept wire transfers. Please call for our banking info. Personal checks take 2 weeks to clear (Miller xmt 350 vs multiprocess welder # 907244 is the responsibility of Lester Bradford) |
l_bradford@cedar--rapids.com (Lester Bradford) for more information.
