|
This is a bar of 0-1 tool steel that measures .500" x 1.500" x 12.250" . It has 3 holes drilled in it because i used it for a back stop for a bridgeport 10" sign plate . I have quite a few small pieces of this material , so if you need a small piece ask and i will see what i have . Most of the pieces are Stentor , Starrett or Brown & Sharpe . Almost all of it like this piece do have some surface rust on them . * CHARACTERISTICS - O1 is an oil-hardening, non-deforming tool steel which can be hardened at relatively low temperatures. Tools and dies made from O-1 will have good wearing qualities since the tungsten and higher chromium content gives improved wear resistance over the straight manganese grades. * WORKABILITY - - Machinability is high. Grindability is high. * APPLICATIONS - Blanking Dies, Bushings, Forming Dies, Master Tools, Forming Rolls, Guages, Trim Dies (Bar of 0-1 tool steel 1/2" x 1 1/2" is the responsibility of Bridget Lindsey) |
bridgetlindsey@cedar--rapids.com (Bridget Lindsey) for more information.
