This is for One very nice used counter sink/bore cutter tool holder. Shank Diameter is 1.5" and on the inside it measures 7/8" right at the end of the holder, then just past that point up inside the holder it steps up just a little bit larger in diameter then down in there about 3/4" or so it of course steps back down to a smaller diameter to keep your cutter centered in the holder. If you need a specific size of anything just ask. If in Michigan add 6% sales tax. Thanks! (Counterbore cutter eclipse twist lock tool holder 7/8" is the responsibility of Britney Henry) |
britney.henry@cedar--rapids.com (Britney Henry)
for more information.