YOUR SOURCE FOR WELDING SUPPLIES MILLER WELDERS -HOBART WELDERS- THERMAL ARC WELDERS- LINCOLN WELDERS- SAFETY SUPPLIES -VICTOR TORCH SETS ARCAIR SLICE PACKS - LENCO SPOT WELDERS The Millermatic® 140 is perfect for light fabrication, garage/body shops, auto body, and at home. It welds material 24 gauge to 3/16 inch. This all-in-one MIG machine has infinite voltage control with wire feed speed tracking for easy operator control. Runs on 115 Volt input power to go wherever you need to weld! * INFINITE VOLTAGE CONTROL with Manual On/Off WIRE FEED SPEED TRACKING provides a broader operating range with finer control by automatically increasing or decreasing wire feed speed when voltage is adjusted. * NEW Smooth Start patent-pending technology provides a smooth spatter-free start .Its the best starting machine in the small MIG machine catagory . No pop gun starts and no spatter to clean up. * DURABLE CAST ALUMINUM FEEDHEAD incorporates dual groove quick-change drive rolls and spring-loaded tension arm with calibrated tension knob all designed to make set up easier and faster. * SEMIAUTOMATIC CONSTANT VOLTAGE WIRE WELDING PACKAGE is capable of welding 24 gauge - 3/16 in (0.8 - 4.8 mm) mild steel. * STANDARD BUILT-IN SOLID STATE CONTACTOR CIRCUIT makes wire electrically "cold" until trigger is pulled. Makes the unit safer, and is easier to position torch to work before starting to weld. * USES 4 or 8 in SPOOLS and can be set up to weld with wire sizes .024 - .030 in mild/staninless steel and .030 -.035 in flux cored. * Add the Spoolmate™ 3035 spool gun and SGA spool gun adapter for welding with .030 (0.8 mm) aluminum wire on 14 gauge to 1/8 in material. * Easy access to output studs provides CONVENIENT POLARITY CHANGEOVER when changing from solid or flux cored wires. * Built-in Contactor - For your safety, our built-in contactor makes wire electrically "cold" when not welding. * Short Circuit Protection - Contact tip life is extended by the exclusive Miller short-circuit protection which easily resets with the release of the gun trigger. * Thermal Overload Protection - Internal components are protected from damage by thermal overload protection which automatically shuts down the unit if duty cycle is exceeded or air flow and cooling are restricted. * Miller's exclusive "Tip Saver" - Short circuit protection shuts down output when tip is shorted to the work. Extends contact tip life and protects internal components from damage. Trigger reset permits quick reset at torch. * Flux Cored ( FCAW ), (gas and self-shielded). * 10 ft (3 m), M-10 Miller MIG gun and cable assembly #195 605. * 10 ft (3 m) work cable and clamp. * Factory-installed gas solenoid valve. * Smith Argon and AR/CO 2 Mix Regulator and gas hose. * Spool of Hobart .024 solid wire and 2 .024 contact tips * 2 contact tips for .030 wire * Dual groove quick-change drive rolls for .024 or .030/.035 wire * Information / settings chart. * Set-up and operation video. B & R WELDER REPAIR SERVICE INC. 4412 SOUTHERN BUSINESS PARK DRIVE Hours : Mon-Fri 8-5 Sat 9-12 EST Email questions to : gracelarson@cedar--rapids.com we only accept wire transfers. Please call for our banking info. Personal checks take 2 weeks to clear (Millermatic 140 mig welder & cart 907311011 is the responsibility of Grace Larson) |
gracelarson@cedar--rapids.com (Grace Larson)
for more information.