MAKE YOUR OWN Holders , for Sltting saws Endmills , Slotdrills , each Morse is case Hardened on Taper only the unfinisehed end is soft , both end's are centred, just place Morse in lathe single or Tail stock and drill hole to suit shank required , a Reamered hole is better , you can then drill & tap a grub screw into side of hole and turn Holder into a side lock holder, great for specials , or cheaper version of Collet chuck for Mill. MORSE TAPER ENDS CAN BE TAPPED TO SUIT A DRAW BAR FOR YOUR AMCHINE IF REQUIRED other sizes available list below Others available on request at harvey_strong@cedar--rapids.com (Morse taper blanks 3MT x 24MM is the responsibility of Harvey Strong) |
harvey_strong@cedar--rapids.com (Harvey Strong)
for more information.